The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.

Log in or Sign up

Precision M4300- Inventor

Discussion in 'Dell Latitude, Vostro, and Precision' started by KaszveL, Nov 29, 2008.

Thread Status:: Not open for further replies.

KaszveL Newbie

Reputations:

0

Messages:

1

Likes Received:

0

Trophy Points:

5

Hey guys/girls, new here; I run Autodesk Inventor 08 on my fairly new M4300, it runs fairly well but one thing really bothers me, I usually leave inventor on and multitask while I work on it but when I switch back to inventor (after leaving it idle) and rotate w/e I'm working on I experience a slight lag followed by what looks like a 3d mess. If i turn the Nvidia control setting on performance or balance I don't get the 3d mess but I still experience the slight lag. I didn't mind it at first but it gets very annoying during assembly. Is there anyway I can fix this? I have the latest driver installed and 4 gigs of ram.

thanks

KaszveL, Nov 29, 2008

#1