The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.

E6400: 2 external monitors - laptop not booting

Discussion in 'Dell Latitude, Vostro, and Precision' started by embedded, Apr 6, 2014.

Thread Status:
Not open for further replies.
  1. embedded

    embedded Notebook Guru

    Reputations:
    0
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    15
    Hi

    I just received my new Dell U2412M monitor connected via DP that goes together with my old 22" Dell connected via VGA.
    The problem I'm facing is that laptop does not boot - it starts and immediately enters a mode where 3 locks buttons light up and nothing happens.
    only when I disconnect the DP connector it starts and then I can hook it up back again and everything works fine.

    I've updated the BIOS to latest version - still no go.
    I have the integrated Intel graphics.

    Does anyone know how to solve such issue?

    10x
     
  2. Commander Wolf

    Commander Wolf can i haz broadwell?

    Reputations:
    2,962
    Messages:
    8,231
    Likes Received:
    59
    Trophy Points:
    216
    So it doesn't boot even if you just have the monitor on DP connected? What if you connect a different monitor with DP?
     
  3. embedded

    embedded Notebook Guru

    Reputations:
    0
    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    15
    I have only 1 monitor with DP connector.
     
Loading...
Thread Status:
Not open for further replies.

Share This Page