The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.

About detaching the dvd drive from E4300

Discussion in 'Dell Latitude, Vostro, and Precision' started by kerrylau, Nov 27, 2008.

Thread Status:
Not open for further replies.
  1. kerrylau

    kerrylau Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    How to detach the dvd drive from E4300? Can it be detached just like the HDD drive easily? Is there an air bay module (or a cover) for the hole of the dvd drive? thanks
     
  2. John Ratsey

    John Ratsey Moderately inquisitive Super Moderator

    Reputations:
    7,197
    Messages:
    28,839
    Likes Received:
    2,157
    Trophy Points:
    581
    See the service manual for the removal instructions.

    I don't think there's a cover for the bay. Dell have had problems supplying the correst weight saver module for the E6400 but, as and when they sort this out, the module may also fit the E4300 is the burner is the same 9.5mm thickness.

    John
     
  3. PvD

    PvD Notebook Consultant

    Reputations:
    16
    Messages:
    156
    Likes Received:
    0
    Trophy Points:
    30
    1 Close the display and turn the computer upside-down
    2 Remove the memory cover.
    3 Remove the M2.5 x 5-mm screw securing the optical drive to the system board. The screw is located in the center of the lower-left edge of the memory module compartment.
    4 Using a scribe, push on the tab that held the screw to slide the optical drive from its slot on the side of the computer.

    [​IMG]
     
Loading...
Thread Status:
Not open for further replies.

Share This Page