The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Packard Bell ETNA-GL how to dissasemble please

    Discussion in 'Packard Bell' started by Midlifelwt, May 4, 2011.

  1. Midlifelwt

    Midlifelwt Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    I have broken the DC input to the laptop. I can get a new one and its just a solder job but I cannot get the case and keyboard apart. I have taken every screw known to mankind out. I have tried to push the keyboard tabs in to remove the keyboard but there is still something holding it together in the middle. I could throw the thing out of the window in frustration.

    Has any genius got any ideas or in fact disasembled one before. I must add I am not a novice so this is really annoying.

    Thanks in advance
     
    Midlifelwt, May 4, 2011
    #1
  2. ComputerShoppe

    ComputerShoppe Newbie

    Reputations:
    0
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    5
    I know its an old post but i can tell you this keyboard is infact GLUED in - getting it out without bending it is not easy. Even harder is getting it to clip back in at the top with even the slightest of bend or warp. The price of a new keyboard is a joke also so be extra extra careful anyone attempting this.
     
    ComputerShoppe, Nov 30, 2011
    #2