The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    project 001 acer travelmate

    Discussion in 'Notebook Cosmetic Modifications and Custom Builds' started by arlaix, Jul 12, 2008.

  1. arlaix

    arlaix Notebook Enthusiast

    Reputations:
    0
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    5
    Item Bought for project>
    Triple-Thick Crystal Clear Glaze. x1 can
    Fusion for Plastic Red Pepper.x1 can
    3M fine sand paper.x 2 pcs
    Screw Drivers Set>x1

    ok guys i planning to spray my acer travelmate to ferrari notebook.
    IS my first time doining it so need advise what are the steps?

    Found info from fusion
    aFor old plastic, use an ammonia-based cleaner and wipe down to clean surface. If the plastic is new, wipe down with paint thinner for best results. Lightly sand glossy surface if previously painted and remove dust with a tack cloth. When dry, apply Krylon® Fusion for Plastic according to the directions on the can. > so is it good enough?
     
    arlaix, Jul 12, 2008
    #1
  2. arlaix

    arlaix Notebook Enthusiast

    Reputations:
    0
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    5
    so do anyone has experience with stripping out travelmate notebook? or is there any webpage about stripping acer notebook?
     
    arlaix, Jul 12, 2008
    #2
  3. arlaix

    arlaix Notebook Enthusiast

    Reputations:
    0
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    5
    arlaix, Jul 25, 2008
    #3