The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Toshiba A660 / A665 16" convert from 768p to 1080p resolution

    Discussion in 'Notebook Cosmetic Modifications and Custom Builds' started by dvstudio3, Oct 20, 2010.

  1. dvstudio3

    dvstudio3 Notebook Enthusiast

    Reputations:
    0
    Messages:
    36
    Likes Received:
    1
    Trophy Points:
    16
    Hi,

    I'm thinking of swapping out the 16" screen from my Toshiba A660 (i7-740QM / GT -330M / 4GB DDR3) to a higher resolution screen however I was just wondering if it will work?

    I know for a fact that the GT330M supports higher resolutions but the screen lacks the support for it (only 1366x768). For a 16" screen the default resolution is a bit small and hence the reason why I plan on swapping it out.

    Any thoughts? Should I even attempt it?
     
    dvstudio3, Oct 20, 2010
    #1
  2. svcr0c0

    svcr0c0 Notebook Consultant

    Reputations:
    1
    Messages:
    141
    Likes Received:
    11
    Trophy Points:
    31
    If your exact model was offered with 768p and a 1080p screens as options, then it's almost guaranteed to work. However the cost of the new screen may make the swap too expensive. It might be cheaper to just sell your current laptop and buy a new one with better specs.
     
    svcr0c0, Oct 21, 2010
    #2
  3. Star Forge

    Star Forge Quaggan's Creed Redux!

    Reputations:
    1,676
    Messages:
    2,700
    Likes Received:
    10
    Trophy Points:
    56
    Not really, ScreenCountry.com has 1080p LED Screens for only $100 USD, I doubt his A660 is worth that low at all. It is good investment really, I am planning on doing the same to my current Envy.
     
    Star Forge, Nov 12, 2010
    #3