The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    M1330 Laser Etching??

    Discussion in 'Notebook Cosmetic Modifications and Custom Builds' started by Mikeoo17, Oct 21, 2008.

  1. Mikeoo17

    Mikeoo17 Notebook Deity

    Reputations:
    261
    Messages:
    731
    Likes Received:
    1
    Trophy Points:
    30
    Just wondering if anyone thinks this could be done. The lid feels like metal which would work well except I'm worried that the paint might slowly flake off due to normal wear and tear where the laser has cut through. Also, would the magnesium palm rest accept laser etching?

    I'm starting a business and want to get my logo etched in. I also want some contact info etched in to make it easy to return to me if lost. I think it would also help to deter thieves based on the fact that it would be very unique and hard to sell.

    Any input or advice would be great
     
    Mikeoo17, Oct 21, 2008
    #1
  2. LTDesignUSA

    LTDesignUSA Notebook Enthusiast

    Reputations:
    36
    Messages:
    27
    Likes Received:
    0
    Trophy Points:
    5
    The problem with laser etching is you sometimes have a trial and error factor here. many times you have to do a few trials runs before you get it right.

    Branding is a huge theft deterrent and we do lots of units just based on this factor.
     
    LTDesignUSA, Oct 23, 2008
    #2
  3. K-TRON

    K-TRON Hi, I'm Jimmy Diesel ^_^

    Reputations:
    4,412
    Messages:
    8,077
    Likes Received:
    2
    Trophy Points:
    205
    The main problem with etching is that it is done with a laser cutter.
    To do laser etching properly lots of tests need to be done to get the power of the laser right, and the speed of the laser perfect. You mainly want a medium speed cut, (for accuracy) and the lowest power laser settings to etch the surface (so the materials does not burn)
    This will take a lot of tests to get right, since every plastic is differnent.
    So it may be a good idea to buy 2 more lids before you decide about etching. You will need one for a ton of small tests, and one for a quick test before final test, and one for the final (if the test before final is not good enough)

    K-TRON
     
    K-TRON, Oct 24, 2008
    #3