The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    wireless Belkin pre-n router not responding after firmware

    Discussion in 'Networking and Wireless' started by makeitcount, Feb 20, 2007.

  1. makeitcount

    makeitcount Notebook Enthusiast

    Reputations:
    0
    Messages:
    43
    Likes Received:
    0
    Trophy Points:
    15
    After setting everything up I decided to update the firmware of my router, and for some reason I got the "Page cannot be displayed" after a little while, and now it's impossible to find the router (I just get a page cannot be displayed/found not sure which) and I've tried hitting the reset button a few times.

    Anyone who has any suggestions?
     
    makeitcount, Feb 20, 2007
    #1
  2. makeitcount

    makeitcount Notebook Enthusiast

    Reputations:
    0
    Messages:
    43
    Likes Received:
    0
    Trophy Points:
    15
    Ah crap. It's a few years old so doubt it's under RMA. So nothing to do with a corrupted firmware? :(
     
    makeitcount, Feb 20, 2007
    #2
  3. blue68f100

    blue68f100 Notebook Virtuoso

    Reputations:
    1,020
    Messages:
    3,439
    Likes Received:
    0
    Trophy Points:
    105
    Try Holding down the reset button then connect the power . Do this for 15 sec, release the reset and see it it clears it.
    On some routers the will clear cmos and allow you to reload the firmware.
     
    blue68f100, Feb 21, 2007
    #3
  4. makeitcount

    makeitcount Notebook Enthusiast

    Reputations:
    0
    Messages:
    43
    Likes Received:
    0
    Trophy Points:
    15
    They decided to replace it, thanks for all the help.
     
    makeitcount, Feb 21, 2007
    #4