The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    minipci antennas in your laptop screen.Where should you place them? What tape should I use

    Discussion in 'Networking and Wireless' started by piggydog, Feb 19, 2007.

  1. piggydog

    piggydog Newbie

    Reputations:
    0
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    5
    Of all the laptops I've taken apart the antennas are on the top left and top right underneath the LCD. Being a curious junkie I'm looking for better coverage and found out that according to netstumbler I get better overall coverage placing 1 antenna on the top right and bottom left, diagonally from each other. So far my sample is far too small, just my house and neighborhood and my brother's house.

    Some look like they lead tape attached to the metal supports of the lid to simulate an antenna dish. I'm thinking there might be a option to increase coverage. Any ideas would be great and I'll report back here. I'm also considering an Engenius 400mw minipci card. Has anyone tried this? I'm currently running an intel 2200bg but in for best coverage my old orinoco
     
  2. blue68f100

    blue68f100 Notebook Virtuoso

    Reputations:
    1,020
    Messages:
    3,439
    Likes Received:
    0
    Trophy Points:
    105
    On my laptop they are on top each side as you describe. When placed up high they are less likely to be blocked. When dual antennas are set near each other they generate a different field. Similar to a figure 8, with the signal being boosted ( increased dbi gain) front to back and weaker off the sides. With some firmware you can select A, B or diverisity.

    While you are testing rotate you nb slowly 360deg to see if the signal increases. If you have noticed most of all the newer units (router/AP) have gone to a single antenna. This gives a omini pattern.