The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Wireless network on combined network

    Discussion in 'Networking and Wireless' started by aknight, Jul 26, 2015.

  1. aknight

    aknight Notebook Guru

    Reputations:
    5
    Messages:
    64
    Likes Received:
    0
    Trophy Points:
    15
    Hi all,

    I live in a block of flats which has a combined wifi policy throughout the building which is the only option for internet service. It has a small limit on the number of devices you can connect to the network and so you have to disconnect one device in the settings to then add another which is pretty frustrating.

    I was wondering if it is possible to use a old router I have lying about to be like the sole 'device' to connect to the network and then for it to send out its own network that I can connect all of my devices to simultaniously without the need of constantly taking devices on and off the list.

    I have used old routers as range extenders and things before but I'm not sure if this way is possible and so I was hoping someone with more knowledge on the subject than myself could point me in the right direction.

    Cheers,

    Andy
     
  2. downloads

    downloads No, Dee Dee, no! Super Moderator

    Reputations:
    7,729
    Messages:
    8,722
    Likes Received:
    2,230
    Trophy Points:
    331
    It is doable and it should work pretty much the same as with any extender however that also means that you effectively cut i half any throughput you have. Since your extender will have to work two ways - anything it downloads from the network if at the same time uploads to your device that requested it and the other way around.

    It might not be a problem if you have a reasonably fast router and a reasonably slow Internet connection, but if it;s an old 802.11g router and a quick connection you will end up losing quite a lot of throughput this way.
     
  3. aknight

    aknight Notebook Guru

    Reputations:
    5
    Messages:
    64
    Likes Received:
    0
    Trophy Points:
    15
    Ahh OK thats good to hear at least. The speed isn't amazing so it could be worth it. What would I set it up as? A repeater or a slave router or something? I'm just not really sure how to get it to take in a signal and then send one out again, like I can't really see the settings for it in the settings.

    Cheers.
     
  4. downloads

    downloads No, Dee Dee, no! Super Moderator

    Reputations:
    7,729
    Messages:
    8,722
    Likes Received:
    2,230
    Trophy Points:
    331
    As a repeater. What router is it exactly?
     
  5. aknight

    aknight Notebook Guru

    Reputations:
    5
    Messages:
    64
    Likes Received:
    0
    Trophy Points:
    15
    Its a Huawei HG533, just one of those ones you get when you sign up to internet from someone that I had lying around.
     
  6. downloads

    downloads No, Dee Dee, no! Super Moderator

    Reputations:
    7,729
    Messages:
    8,722
    Likes Received:
    2,230
    Trophy Points:
    331
    It's very hard to figure it out without proper documentation. I tried looking at screenshots from different menus on the Internet but it's not enough.
    It seems it's possible to set it up as an AP but I can't find anything about a repeater.
     
  7. aknight

    aknight Notebook Guru

    Reputations:
    5
    Messages:
    64
    Likes Received:
    0
    Trophy Points:
    15
    Ahh ok, I'll see if I can find another router and go from there. Thanks very much for your help.