The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Wireless Signals Too Weak

    Discussion in 'Networking and Wireless' started by prabby81, Jun 25, 2012.

  1. prabby81

    prabby81 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Hello experts,

    I bought my Sony Vaio (Model - VPCEH25EN) around 6 months back. I faced some issues with my hard disk having bad sectors a month back and it was eventually changed under the manufacturer's warranty.

    Immediately after I received it back, I started facing issues with my wireless signals. I used to receive full signal strength earlier, but now I was just receiving 2 bars out of 5. This meant that my wireless kept disconnecting again and again, and when it did not disconnect, I received bad speed. The issue is still persistent.

    When I try connecting other laptops at my home through the same wireless router, it connects well with full signal strength. This clearly shows that there's nothing wrong with the router, but something with either the drivers of my Atheros AR9285 or with that itself.

    I have Win 7 Home Basic 64 bit running on my system. Also, I have installed 9.2.0.427 drivers for Atheros AR9285. Please let me know if any other information is required.

    Can somebody help me with this?

    Thanks,
    Prabby
     
  2. downloads

    downloads No, Dee Dee, no! Super Moderator

    Reputations:
    7,729
    Messages:
    8,722
    Likes Received:
    2,230
    Trophy Points:
    331
    Check if both antenna leads are actually connected.
    Also AR9295 is crap- it doesn't work properly with 802.11n networks so change yours to 802.11g just for testing.
    It may not resolve disconnecting issues as these seem to be related to poor signal reception but it should help you with low speeds you're getting while you're connected.
     
  3. prabby81

    prabby81 Newbie

    Reputations:
    0
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    5
    Thanks for the reply... I'll test it and come back...