The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Using more WiFi attennae for stronger signal?

    Discussion in 'Networking and Wireless' started by ridestp, Sep 27, 2008.

  1. ridestp

    ridestp Notebook Guru

    Reputations:
    17
    Messages:
    60
    Likes Received:
    0
    Trophy Points:
    15
    {This is on the Acer Aspire One}

    So I just got my new LCD top cover plastic body piece from Kevin at SourceITs. I was surprised to see that it also came with the hinge, microphone, WiFi antennae, and RF shield.

    My question is if I can use the extra antennae in any way to boost my signal. It has the white wire and the black wire. Could I splice these into the current wires so that I have 2 of each?

    Thanks in advance!
     
  2. K-TRON

    K-TRON Hi, I'm Jimmy Diesel ^_^

    Reputations:
    4,412
    Messages:
    8,077
    Likes Received:
    2
    Trophy Points:
    205
    i dont know if that will work. If you look at the antennae, the antennae are usually just a wire which is either connected to a screw on the inside of the lid, or the small metal brackets which house the latches.
    Lengthining the cable may help, but I doubt splicing it will.
    You may loose a lot of the signal strength from splicing the wire.

    K-TRON
     
  3. DetlevCM

    DetlevCM Notebook Nobel Laureate

    Reputations:
    4,843
    Messages:
    8,389
    Likes Received:
    1
    Trophy Points:
    205
    Sony uses two antennas in the G series - so its possible.
    But if its two connected wires then they are connected for a reason.
     
  4. metril

    metril Notebook Deity

    Reputations:
    420
    Messages:
    968
    Likes Received:
    0
    Trophy Points:
    30
    Splicing will actually ruin your signal since the power has to then be split between two antennas. You are better off using a larger antenna or making something to focus the signal.