The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Unused antenna cables in M1330

    Discussion in 'Networking and Wireless' started by brushless, Nov 18, 2010.

  1. brushless

    brushless Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Being a newbie ...why are there so many unused antenna cables in the wireless chamber of my Dell XPS M1330.
    My quest is to get wireless coverage in the rear bedroom of my flat. I can get coverage of my work wireless connection inside the freezing front door and then disappears as I go upstairs.

    How can I bridge that 30feet?
     
  2. Nick

    Nick Professor Carnista

    Reputations:
    3,870
    Messages:
    4,089
    Likes Received:
    643
    Trophy Points:
    181
    Some of the wires are for the(optional) mobile broadband card.
     
  3. huai

    huai Notebook Consultant

    Reputations:
    5
    Messages:
    238
    Likes Received:
    2
    Trophy Points:
    31
    If you have a CCFL backlit screen, you have 5 antennae wires - 2 for a Wireless-G card (Black and White), third one that would be used for higher end wireless N cards (Intel 5300 and 6300) (Gray), a bluetooth antenna (Blue) and one more for the WLAN card if you have one (I dont recall the color).

    With LED backlit screen you don't get a third wire for wireless N cards.
     
  4. flipfire

    flipfire Moderately Boss

    Reputations:
    6,156
    Messages:
    11,214
    Likes Received:
    68
    Trophy Points:
    466
    Wireless signals dont travel well upstairs. Your gonna need to reposition your current router or buy another router/repeater.
     
  5. weinter

    weinter /dev/null

    Reputations:
    596
    Messages:
    2,798
    Likes Received:
    1
    Trophy Points:
    56
    It doesn't travel upstair because the signal propagate parallel to the antenna
    (((((((((((((((( || )))))))))))))))))))
    So the solution is to shift the antenna to this = position.
     
  6. flipfire

    flipfire Moderately Boss

    Reputations:
    6,156
    Messages:
    11,214
    Likes Received:
    68
    Trophy Points:
    466
    Router antennas are omnidirectional.

    brushless: What router do you have?
     
  7. weinter

    weinter /dev/null

    Reputations:
    596
    Messages:
    2,798
    Likes Received:
    1
    Trophy Points:
    56
    All routers antenna are X/Y Axis (|_) directional unless stated otherwise.
    Check Books on Wireless Networking Technology.
     
  8. flipfire

    flipfire Moderately Boss

    Reputations:
    6,156
    Messages:
    11,214
    Likes Received:
    68
    Trophy Points:
    466
    Rubberduck/dipoles are omnidirectional on a horizontal plane with vertical beamwidth of 75deg~, so it travels upward as well given the space.

    [​IMG]

    Pointing the antenna like you said wouldnt help him because his room is in the rear of his flat. The horizontal signals now would be focused vertically to the ceiling, putting him on a weaker spot.
     
  9. unreal25

    unreal25 Capt. Obvious

    Reputations:
    1,102
    Messages:
    2,373
    Likes Received:
    0
    Trophy Points:
    55
    If most power is radiated in the horizontal direction, how about try rotating the router/antenna by 90 degrees ? I'm not sure where is he trying to get the signal: up or in the back room on the same floor? If it's on the same floor, try moving the router to another place if your cable allows it.
     
  10. weinter

    weinter /dev/null

    Reputations:
    596
    Messages:
    2,798
    Likes Received:
    1
    Trophy Points:
    56
    Isn't his room on the second floor like most flats vertically above the first floor?
    Anyway placing the router in higher position will help as well.
     
  11. brushless

    brushless Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    My circumstances are thus:- I live very close to my workplace. I can get my employers wireless connection at home albeit inside the front door of my flat wearing hat and scarf LOL LOL. I have a legit connection for work. It's when I go upstairs to the rear of the house I loose connection. How do I span that crucial 25 feet? I have heard of a repeater and the "Turbo Tenna" etc.