The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    OpenWRT "Bleeding Age" crash issue

    Discussion in 'Networking and Wireless' started by tufani, Dec 4, 2008.

  1. tufani

    tufani Newbie

    Reputations:
    0
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    5
    Hi ,

    I have flashed my NetgearWGR614L with OpenWRT"Bleeding Age" firmware .... It was working OK ...

    I changed some configuration files (/etc/config/wireless, /etc/config/network & /etc/config/firewall) and rebooted the board ... it was OK ... Idid this sequence several times but after few times my board suddenly crashed while rebooting and now I

    am not able to boot it again ....

    As far as this firmware is concerned ... I have tested it several times and it was working OK ...

    Could anybody plz help me in this regard,

    thnx in advance ,
     
    tufani, Dec 4, 2008
    #1
  2. tufani

    tufani Newbie

    Reputations:
    0
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    5
    sorry for my spelling mistake ... it should be OpenWRT "Bleeding edge"
     
    tufani, Dec 4, 2008
    #2
  3. Shyster1

    Shyster1 Notebook Nobel Laureate

    Reputations:
    6,926
    Messages:
    8,178
    Likes Received:
    0
    Trophy Points:
    205
    You're much more likely to have success at your other thread on myopenrouter.com.
     
    Shyster1, Dec 5, 2008
    #3