The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Lynksys WRT54G2 connecting help

    Discussion in 'Networking and Wireless' started by NeoNeder, Jan 30, 2009.

  1. NeoNeder

    NeoNeder Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Hello guys Im fairly new at all of this, I bought myself a WRT54G2 lynksys router. So whenever I try to acces 192.168.1.1 it keeps asking me for login pass and user, but the user and pass I put up when setting up the router won't work? I've also tried resetting the router and installing it again even but it won't go through? Its not the security code either cause it won't work. So what is it? Or how can I change that, I really need to connect to my router. Thanks in advance :confused:
     
    NeoNeder, Jan 30, 2009
    #1
  2. silvertower666

    silvertower666 Notebook Enthusiast

    Reputations:
    11
    Messages:
    11
    Likes Received:
    0
    Trophy Points:
    5
    Reset the router and set it up manually. If you can figure out how to get to the configuration webpage, then you can do the rest of the setup without using the setup disk.
     
    silvertower666, Jan 30, 2009
    #2
  3. namaiki

    namaiki "basically rocks" Super Moderator

    Reputations:
    3,905
    Messages:
    6,116
    Likes Received:
    89
    Trophy Points:
    216
    Read the instruction manual for the default username and password.
     
    namaiki, Jan 30, 2009
    #3
  4. NeoNeder

    NeoNeder Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Thanks finally got it.
     
    NeoNeder, Jan 30, 2009
    #4