The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    DC++ not working correctly on Netgear router

    Discussion in 'Networking and Wireless' started by Sponsi, Jun 9, 2007.

  1. Sponsi

    Sponsi Badibade

    Reputations:
    478
    Messages:
    1,869
    Likes Received:
    0
    Trophy Points:
    55
    I setup my Netgear router yesterday, and all went well. The only problem I'm having is using DC++. I connect to servers just fine, but when it comes to searching nothing comes up regardless of the search term. I'm pretty sure this isn't a problem with the server, nor DC++ because I tried it with a wired connection(Just cable modem, and my laptop no router) and it worked just fine. If anyone is familiar, or uses DC++ any help would be appreciated. I'm searching on bghub.ilko.ca.
     
    Sponsi, Jun 9, 2007
    #1
  2. bluefox

    bluefox Notebook Enthusiast

    Reputations:
    2
    Messages:
    19
    Likes Received:
    0
    Trophy Points:
    5
    Have you try DC++ Port Forwarding? maybe this could be the problem.
     
    bluefox, Jun 9, 2007
    #2
  3. Sponsi

    Sponsi Badibade

    Reputations:
    478
    Messages:
    1,869
    Likes Received:
    0
    Trophy Points:
    55
    You're right, I just looked at the help manual and it says not to use direct connection if you're using a router(Obviously I was using that) It gives me directions on how to forward the connections, but if I have any problems I will post back. Thank you!

    Edit: I just followed the directions, and I'm able to search again. Thanks again!
     
    Sponsi, Jun 9, 2007
    #3