The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Bluetooth in XPS M140

    Discussion in 'Networking and Wireless' started by compacteverything, Mar 15, 2006.

  1. compacteverything

    compacteverything Notebook Enthusiast

    Reputations:
    0
    Messages:
    11
    Likes Received:
    0
    Trophy Points:
    5
    All,

    I bought a XPS M140 with integrated Bluetooth. I have a Motorola RAZR V3 and a Jabra BT130 headset.

    I was thinking connecting these 3 devices would be a breeze, but I was wrong.

    When I run the Bluetooth Manager on the M140, it fails to detect my phone or the headset.

    Could anyone please instruct me step-by-step how can I setup these 3 devices.

    Thanks Much
     
  2. Brian

    Brian Working at 486 Speed NBR Reviewer

    Reputations:
    947
    Messages:
    8,970
    Likes Received:
    1
    Trophy Points:
    205
    Both need to be discoverable. Each will have a different process to turn that on.
     
  3. compacteverything

    compacteverything Notebook Enthusiast

    Reputations:
    0
    Messages:
    11
    Likes Received:
    0
    Trophy Points:
    5
    Is there a set of instruction on how to do this?? I checked in the cellphone manaul but there is not much detail.
    As far as the notebook is concerned I will have to contact Dell support.


    THanks
     
  4. Lil Mayz

    Lil Mayz Notebook Deity

    Reputations:
    599
    Messages:
    1,463
    Likes Received:
    0
    Trophy Points:
    55
    I have a similar Jabra heasdet. There should be a button to put the headset in discoverable mode. Refer to the Jabra instruction manual. Also, if you dont have the manual, try holding down the "call" button for a few seconds until the LED light status changes