The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    That little glowing rectangle on the lid of your 1029...

    Discussion in 'MSI' started by Hucsman, Dec 16, 2005.

  1. Hucsman

    Hucsman Notebook Consultant

    Reputations:
    72
    Messages:
    247
    Likes Received:
    0
    Trophy Points:
    30
    So I just built my 1029, will post impressions after I had some time to make sure everything is positively working ok.

    However, something is really bothering me. The bare glowing rectangle is just screaming "ALMOST" finished. What are we going to do about our rectangles?

    I was thinking a transparent decal with a custom logo might do the trick, but are those available in any printing place?

    Ideas welcome.
     
    Hucsman, Dec 16, 2005
    #1
  2. WetWork

    WetWork Newbie

    Reputations:
    1
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    0
    I was thinking printing on a transparency (from any Office Depot) and using spray adhesive to attach it as a tempory fix.
     
    WetWork, Dec 16, 2005
    #2