The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Installing RAM

    Discussion in 'Lenovo' started by brad9995, Aug 11, 2011.

  1. brad9995

    brad9995 Newbie

    Reputations:
    0
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    5
    I just got my t420s and 4gb RAM in the mail. Does anyone have a video walkthrough or pictures of how to install the RAM? I opened the lid with 2 screws on the bottom and found the factory installed 4 gb RAM. Towards the top of the laptop it looks like there might be another place to put it with orange and blue colored wires coming out. I'm not very good with computers, but was told this was an easy and cheap upgrade. Any ideas?
    Thanks in advance!
     
    brad9995, Aug 11, 2011
    #1
  2. John Ratsey

    John Ratsey Moderately inquisitive Super Moderator

    Reputations:
    7,197
    Messages:
    28,842
    Likes Received:
    2,172
    Trophy Points:
    581
    If you found one RAM slot then the other slot in the T420s is just above it. Put the module into the slot at about 45 degrees than push it down to the clips at each side while also pushing the module into the contacts.

    You can get an idea of how it fits by pushing the clips for the module you have to each side. The free side of the module will then spring upwards (push it down again to fix it).

    John
     
    John Ratsey, Aug 11, 2011
    #2
  3. ThiPaX40

    ThiPaX40 Notebook Consultant

    Reputations:
    44
    Messages:
    195
    Likes Received:
    0
    Trophy Points:
    30
    Read the THINKPAD STICKY, there are direct links to both 'ThinkPad Hardware Maintenance Manuals' and 'Service and Support Training'

    That should get you started (and get the job done) :D
     
    ThiPaX40, Aug 11, 2011
    #3
  4. kirayamato26

    kirayamato26 Notebook Deity

    Reputations:
    146
    Messages:
    972
    Likes Received:
    0
    Trophy Points:
    30
    Last edited by a moderator: Jan 29, 2015
    kirayamato26, Aug 11, 2011
    #4