The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    EasyEject Utility and Adv. Mini-Dock "cannot be stopped right now"

    Discussion in 'Lenovo' started by reb.711, Mar 21, 2009.

  1. reb.711

    reb.711 Notebook Enthusiast

    Reputations:
    0
    Messages:
    31
    Likes Received:
    0
    Trophy Points:
    15
    Hi,

    This used to happen every other time or so, but now it happens all the time. Whenever I run the easyeject utility to undock my T400 (Vista Home Premium 32-bit), I get the message "device cannot be stopped right now. Try stopping the device again later." It gives me the same message for my external HD, which is hooked up to the docking station. I also have my external monitor hooked up to the docking station.

    Now recently, I still get that message, but in addition for some reason running the easyeject utility resets my display resolution to the lowest option (800x600). The resolution I use on my external monitor in normally 1920x1200, and my max T400 monitor resolution is somewhere a little less than that. I am able to manually fix the display resolution when this happens after trying to undock, but I'm including that detail in case it helps figure out the problem.

    Thank you!
     
    reb.711, Mar 21, 2009
    #1