The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Chainloading does not work in DIY eGPU Setup 1.x

    Discussion in 'e-GPU (External Graphics) Discussion' started by konpei-island, Dec 9, 2012.

  1. konpei-island

    konpei-island Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Chainloading does not work in DIY eGPU Setup 1.x :(

    My PC is lenovo G560
    windows7 64bit
    One physical HDD
    The partition is only C drive on windows.

    Chainloading does not work in normal menu.win and menu.mbr.

    If grub4dos.Prompt is chosen, it will become a black screen and will stop.
    I installed grub4dos and executed ls (hd[tab] command,
    and hd0 and the partitions 0 and 1 were displayed.
    I edited \config\menu.win into chainloader(hd0, 1)/bootmgr or chainloader(hd0, 0)/bootmgr,
    but Chainloading does not work.

    Please teach a right procedure
    Someone please help me!!
     
    konpei-island, Dec 9, 2012
    #1