The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    Dell Inspiron 1721 - bad board or cpu ?

    Discussion in 'Dell' started by Finch127, Jan 14, 2012.

  1. Finch127

    Finch127 Newbie

    Reputations:
    0
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    5
    Well lads,

    Preforming an inspection here for a client on this model, it died the other night on her while she was just sitting on the desktop, she claimed that it was overheating alot on her.

    When I try to boot it up, the hard disk spins up for 2 seconds, cpu fan DOESNT, power light is solid, then shuts down followed by a flicker of the battery charging light. I thought maybe it was the fan that was gone and maybe it was shutting down because it detected that the cpu fan wasnt spinning , and it was just that particular fan, but ive tried another 2 in it, same problem.

    Also re-seated the cpu, tried different RAM, cleared the cmos, removed the battery to just run on direct power and another power adapter.

    Kinda looks like its the board, but one thing, how come the hard disk is spinning up, even for 2 seconds, and the power lights are active again for 2-3 seconds, if it was the board shouldnt the whole thing be as dead as a doornail ?

    Cheers
     
  2. Commander Wolf

    Commander Wolf can i haz broadwell?

    Reputations:
    2,962
    Messages:
    8,231
    Likes Received:
    63
    Trophy Points:
    216
    CPUs really don't die that often... it's most likely the board (the track record of the 1721/1521 would suggest the same too). There's a lot of stuff that can break on the motherboard, so symptoms of board failure can vary; it's not uncommon for a bad board not to be completely dead.