The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    GPU is working? How to tell?

    Discussion in 'Alienware Area-51/Aurora and Legacy Systems' started by Rotary Heart, Apr 16, 2013.

  1. Rotary Heart

    Rotary Heart Notebook Evangelist

    Reputations:
    253
    Messages:
    621
    Likes Received:
    216
    Trophy Points:
    56
    My GPU usage only shows GPU2 usage. So GPU1 always shows 0% while GPU2 shows correct usage. Also the temps are way different, GPU2 ~75 and GPU1 ~ 65. GPU-Z shows the same things.

    So my question is: Which GPU is GPU1? How can I tell if its working?

    I noticed this since Resident Evil 5 start lagging where it never lagged. Also my benchmark results are lower than the last one I did.
     
  2. Alienware-L_Porras

    Alienware-L_Porras Company Representative

    Reputations:
    3,658
    Messages:
    6,874
    Likes Received:
    969
    Trophy Points:
    281
    Try disabling the xFire or physically removing the card and xFire cable if possible.
     
  3. Rotary Heart

    Rotary Heart Notebook Evangelist

    Reputations:
    253
    Messages:
    621
    Likes Received:
    216
    Trophy Points:
    56
    Will try that as soon as I arrive home tomorrow. Will report back. Thanks for your answer.

    Funny things is that I fresh installed Windows 8 and now it reads gpu load for both and temps are ~2 temp off :) so now it looks like its working well.
     
  4. Alienware-L_Porras

    Alienware-L_Porras Company Representative

    Reputations:
    3,658
    Messages:
    6,874
    Likes Received:
    969
    Trophy Points:
    281
    That's great! I'm glad you got it working :)