hi me again rofl
ok not sure whats going on but im supposed to have 6gb of 1600mhz ddr3
but when i run memory upgrade scans i get these results
using crucial
slot 1 ddr3 pc3-10600
slot 2 ddr3 pc3-12800
using orca
i get 2
total slots 2
slots available 1
slot 1 2gb
slot 2 empty
windows reports
6gb ram installed
any ideas? or am i gonna have to rip her open and see whats in there?
-
smokeydogsmokey Notebook Consultant
-
Mine shows this..
Memory DR3 PC3-10600, DDR3 PC3-12800
Memory Type: DDR3 PC3-10600, DDR3 PC3-12800, DDR3 (non-ECC)
Maximum Memory: 8GB
Currently Installed Memory: 8GB
Total Memory Slots: 2
Available Memory Slots: 0
4GB
4GB
Each memory slot can hold DDR3 PC3-10600, DDR3 PC3-12800 with a maximum of 8GB Kit (4GBx2) per slot.*
*Not to exceed manufacturer supported memory. -
Use HWinfo64 . This will help you figure out your RAM configurations. Most likely both RAM are of different models. But i guess as long as they are of same speed, its not supposed to be an issue. But why did you go for 6 GB anyways? you should have gone for either 4GB or 8 Gb. Memory of same sizes work in "dual Channel" mode. whereas Memory of unequal sizes work in Asynchronous mode and are somewhat less performing then dual channel.
-
smokeydogsmokey Notebook Consultant
-
Its allright. I was just passing on information
But use that software and it will tell you about your RAM. You won't need to open it up see whats under the hood
erm ram miss match??
Discussion in 'Alienware 14 and M14x' started by smokeydogsmokey, Jan 26, 2012.