Alienware m14x r2 problem with memory upgrade

Hi

I bought 2 dell alienware m14x r2. I have bought this memory CMSX8GX3M2A1866C10 for upgrade my alienware but when i try install to my alienware m14x r2 the screen become flash flash and keep flash until freeze ? Then i try to install that memory to my brother alienware m14x r2 its working normal and running at 934 MHz (per 1 stick) both running dual 1866 perfectly without any flash and freeze ??? ? I dont know maybe my alienware having problem with mother board ???

here is detail on my alienware m14x r2 with vieo i have up load video on you tube .
http://www.youtube.com/watch?v=i7xcUMvq2DM

Memory from amazon

CORSAIR Vengeance 8GB (2 x 4GB) 204-Pin DDR3 SO-DIMM DDR3 1866 Laptop Memory


Dell Alienware M14XR2 System BIOS A09

I already update to A09 version.

I have try to run F12 PSA on Bios menu diagnostic and Alienpsy ( No problem Found)

Any help i would appreciated .please.

 

I wish I could help you , that's same happen to me when I install 2133mhz HyperX ram , unless I set 1866mhz it works somehow.

 

so if i understand correctly it just shuts itself off when the jitters starts? if that is the case you may be able to find some detail in the event viewer under system logs. look at the time as the jitter starts and after you reboot check the log for system events during that time. seeing as the system does a "proper shutdown" rather than just rebooting the cause is most likely logged.
hope that helps, good luck!

 

So about 10 mins before midnight on new years eve the Motherboard in my R2 went completely dead. I just got it replaced by a Dell service tech at my office today and as I feared, the 2133 ram that worked perfect in my 1st motherboard would no longer run @2133 once it was replaced I put the stock ram back in before the tech came because I didn't want to get some bag that might try to blame it on the ram and hassle me about it. Luckily, I got sent a cool tech unlike most of my previous onsite service calls. but no matter, its not like they are going to replace it again because it doesn't over-perform as well as the last one. I haven't tried much screwing with settings but set as my last one was, it will not run. ill let anyone interested know if i can find a reason...

 

Hi
Thanks for respond my thread. I just shut down because its flash alot more after restart so that why i have to locate where is the shut down button then i do it by my self. This one having problem when i install 1866 but my brother he has same one with me . He can use perfectly and smooth with 1866 mhz.
Any suggest would appreciate .

 

I have set it to 1866 not auto. but its just flash.

 

so after playing around in the BIOS RAM options I was able to get my HyperX kit running @ 2133. at first it was giving me problems, then I upped the voltage to 1.55 and set it manually @ 2133 and it started working. puzzled by it needing an additional .05 volts, I decided to load the BIOS optimal defaults. I then went in and changed my RAM settings to match the config from the old motherboard (set manually @ 2133, 1.5 volt, default timings) and it is now working again .
for those with issues running high speed RAM you may want to try resetting the BIOS defaults or kicking the voltage up a notch.