The Notebook Review forums were hosted by TechTarget, who shut down them down on January 31, 2022. This static read-only archive was pulled by NBR forum users between January 20 and January 31, 2022, in an effort to make sure that the valuable technical information that had been posted on the forums is preserved. For current discussions, many NBR forum users moved over to NotebookTalk.net after the shutdown.
Problems? See this thread at archive.org.

    About razor mamba

    Discussion in 'Accessories' started by 4everg0ne, Jan 27, 2012.

  1. 4everg0ne

    4everg0ne Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Hi guys, i have a question or more about razor mamba.
    When i am using the wired mode with the battery inside it, i notice there are blinking green lights. May i know is there any problem with it?
    Before the green flashing lights appear, i could use wireless mode and wired mode. After the green flashing lights appear, i could not use wireless mode. And the lights annoys me whenever i am using the com.
    Sry if i am dumb, cos this is my 1st razor stuff.
     
    4everg0ne, Jan 27, 2012
    #1
  2. Baka

    Baka (・ω・)

    Reputations:
    2,228
    Messages:
    2,111
    Likes Received:
    20
    Trophy Points:
    56
    Baka is wondering if that is the green charging lights for the mouse ._. Does it disappear, then go up one bar at a time til there's 3 bars then it disappears and repeats?
     
    Baka, Jan 27, 2012
    #2
  3. 4everg0ne

    4everg0ne Newbie

    Reputations:
    0
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    5
    Nope, its has 3 full bars and its blinking.
     
    4everg0ne, Jan 27, 2012
    #3
  4. reaversedge

    reaversedge Notebook Evangelist

    Reputations:
    271
    Messages:
    640
    Likes Received:
    11
    Trophy Points:
    31
    i also use razer mamba (the 4g version) whenever its charging on dock mode, the dock base color blinks, when you are charging it on wired mode, aside from the 3 bars blinking on the lower left part of the mouse, the color in the scroll should not be blinking.

    now i know that somehow razer mamba has buggy features that happens not often in my case, so whenever i start my laptop and the desktop appears, i usually start the razer mamba config software then click manual calibration by the track pad, then after the mamba should be smooth as cake whether on wireless or wired. if its not function as i stated, there is a problem. so for the meantime this is the least thing you can do.

    1. make sure you have the appropriate drivers and firmware updates on your mamba, (there are two types, the old one and the 4g, both types have different driver version.
    2. make sure you follow the firmware update procedures right.
    3. after finishing the installation, reboot (mamba on wired mode, manually calibrate)

    otherwise you can visit their official website forums for questions. i don't have problems in my mamba (the only minor thing is tracking time for the mouse device when on wireless mode as i open the razer mamba configuration software which takes 20 seconds, ugh)
     
    reaversedge, Jan 27, 2012
    #4
  5. Mastershroom

    Mastershroom wat

    Reputations:
    3,833
    Messages:
    8,209
    Likes Received:
    16
    Trophy Points:
    206
    When you plug the Mamba in, the green battery indicator lights will flash to indicate charging. If the mouse's power switch is off, then the green lights will become steady green with all three bars once the mouse is fully charged. If the power switch is on, the lights will still flash even when the mouse is fully charged.

    Silly question, but did you make sure the power switch is on when you tried to use wireless mode again? Also, try hitting the sync buttons simultaneously; one on the bottom of the Mamba itself, and one on the front of the dock.
     
    Mastershroom, Jan 27, 2012
    #5