This is the second time the port has failed on me. I have to hold cables at an angle to get them to work. I've been an SE for many years and have never seen such terrible manufacturing on an ethernet port. They all fail the exact same way with the bottom of the plastic where the pins sit breaks off a tiny tab in the rear so the plastic gets pushed down when any cable is inserted. I am betting a large percentage of users don't even use their network ports which would be why it hasn't been reported as a large issue. I haven't even used the ethernet port three times since the last replacement.
-
I used the port a lot but its still going. you sure your cable isnt killing the port?
-
Different cables. Shouldn't matter as they are all RJ45 anyway. If you can wiggle it side to side yours will fail eventually too =/
-
cruisin5268d Notebook Evangelist
Literally the worst?
I have gone through 5 different motherboards and not a single issue with the onboard NIC -
3 motherboards, 2 NIC's =/
-
-
My 17R3 Ethernet port seems fine. RJ45 connects snugly without wiggle. These are very standard, mass produced components probably made by Foxconn or whoever. *shrugs*
-
Papusan likes this.
-
-
-
-
Alienware 17 R3 has literally the worst ethernet port ever manufactured
Discussion in '2015+ Alienware 13 / 15 / 17' started by LVNeptune, Sep 19, 2016.